Télécharger Imprimer la page

Inventum IVW6010A Manuel D'utilisation page 45

Publicité

Les langues disponibles

Les langues disponibles

Problem
The dishes are not dry.
There are rust stains on the dishes.
FAULT CODES
The fault codes are shown on the display of the control panel.
Program selector
Possible cause
button
Quick '30, blinks
There is insufficient water
supply.
Quick '30 and Quick
The heater has an error.
'90, blinks
Eco, blinks
The safety for water overflow is
activated.
9
General terms and conditions of service and warranty
We do not need to remind you of the importance of service. After all, we develop our products to a standard so that
you can enjoy them for many years, without any concerns. If, nevertheless, there is a problem, we believe you are
Possible cause
The level of water hardness is set
too low, which affects the salt
consumption.
The cap of the salt reservoir is not
closed correctly.
The selected program does not
include drying.
The level of rinse aid consumption is
set too low.
The appliance is unloaded too
quickly after the program is finished.
The stainless steel quality of the
dishes is insufficient.
The level of salt consumption is set
too high.
The cap of the salt reservoir is not
closed correctly.
Any spilled salt during filling of the
salt reservoir was not cleaned
immediately.
The water supply is polluted.
Possible solution
Make sure that the water tap is fully open and that
the water supply is not blocked.
Close the water tap, remove the water inlet hose and
do a check if the hose is clogged.
Start the appliance again.
Contact the Inventum-servicedienst if the fault code
keeps re-occuring.
Contact the Inventum-servicedienst.
Contact the Inventum-servicedienst.
Possible solution
Adjust the level of salt consumption.
'Setting the level of
Refer to section
salt consumption'
.
Make sure that the cap of the salt
reservoir is closed firmly.
Choose a program that includes
'Programs'
drying. Refer to section
Adjust the level of rinse aid
consumption. Refer to section
'Setting the level of rinse aid
consumption'
.
Wait a few minutes after the program
is finished before you unload the
appliance.
Make sure that you only clean
dishwasher-safe dishes in the
appliance.
Adjust the level of salt consumption.
'Setting the level of
Refer to section
salt consumption'
.
Make sure that the cap of the salt
reservoir is closed firmly.
Make sure that you clean any spilled
salt immediately and run a full
program to prevent corrosion.
Do a check on the water supply.
English
.
45

Publicité

loading