Toro 22in Recyler Manuel D'utilisation page 15

Folding the Handle
WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Remove and save the 2 handle knobs and 2 carriage
bolts from the handle brackets
Important: Route the cables to the outside of the
handle knobs as you fold the handle.
1. Handle knob (2)
2. Fold the handle by rotating it forward
1. Operating position
3. Insert the carriage bolt (with the bolt head toward the
inside) through the handle bracket and the upper hole
in the handle end. Ensure that the square edges of each
carriage bolt fits into the upper or lower square hole in
its related handle bracket.
4. Loosely install the handle knobs and carriage bolts on
the handle brackets.
(Figure 23).
Figure 23
2. Carriage bolt (2)
(Figure
Figure 24
2. Folded position
5. To unfold the handle, refer to
Unfolding the Handle (page
g189871
24).
g193193
14
1 Assembling and
4).