Adjustment - Alpine SWD-2000 Mode D'emploi

3. CHECK
1 Secure all loose cables.
CAUTION - ARRANGE THE WIRING SO IT IS NOT CRIMPED OR PINCHED BY A
SHARP METAL EDGE. Route the cables and wiring away from moving parts (like the seat
rails) or sharp or pointed edges. This will prevent crimping and damage to the wiring. If
wiring passes through a hole in metal, use a rubber grommet to prevent the wires insulation
from being cut by the metal edge of the hole
2
Reconnect the negative lead to the battery terminal
3
By switching on the head unit, verify that the subwoofer is working.
4
Check that all electrical functions of the car are operational. (lights, indicators, horn etc.)

4. ADJUSTMENT

GAIN ADJUSTMENT
1
BASS EQ ADJUSTMENT
2
LOW PASS FILTER ADJUSTMENT
3
CAUTION
DO NOT EXCEED THE INPUT LEVEL SPECIFIED FOR THIS PRODUCT.
If there is distortion or a popping noise from the subwoofer the input level is too high.
If the subwoofer has prolonged use in this condition, this may result in deterioration of
performance or may cause damage to the subwoofer.
.
1 2 3
EN
9