Packing List - Alpine SWD-2000 Mode D'emploi

SPECIFICATIONS
MAX POWER OUTPUT.......................................................
CROSSOVER....................................................................
INPUT IMPEDANCE............................................................
OPERATIONAL VOLTAGE...................................................
EARTH TYPE.....................................................................
SENSITVITY......................................................................
DIMENSIONS.....................................................................
WEIGHT............................................................................

PACKING LIST

PRODUCT NAME
3-Pin connector
Power lead extension cable (5.5M)
Remote turn on extension cable (5.5M)
Scotch lock connector
INTRODUCTION
• Please ensure that there is sufficient length of the various cables for your desired
subwoofer location.
• Certain products are incompatible with this subwoofer. Please read the instructions of
the product that will be used with the SWD-2000, alongside this manual during
installation.
1. INSTALLATION
Park the car at a safe place, on a level surface. Apply the handbrake and remove the key.
1
Work out where to install the subwoofer, and check that there is sufficient cable length.
2
Carry out the Installation.
WARNING - DO NOT DAMAGE PIPE OR WIRING WHEN DRILLING HOLES.
holes in the chassis for installation, take precautions so as not to contact, damage or obstruct pipes,
fuel lines, tanks or electrical wiring. Failure to take such precautions may result in fire.
QTY
PRODUCT NAME
1
Speaker to RCA connector (1M)
1
Mounting brackets
1
Self tapping screw
4 Machine screw
350W
50~200Hz
18k Ω (Line Input)
36k Ω (Speaker Input)
DC 14.4V (Operational
between: 11~16V)
Negative Earth
96dB/10W.m
350mm x 300mm x 198mm
8.5kg
When drilling
EN
QTY
2
4
8
4
5