AC Infinity AIRTAP Serie Manuel D'utilisation page 17

PROGRAMMING
HEATING TRIGGER
Use this mode to set the temperature trigger for your heater. Please note
you are NOT setting your desired temperature.
In this mode, the fans will run if the probe temperature meets or rises
above the trigger's hot temperature setting. It will not run if the probe
temperature is below the trigger's hot temperature setting.
Press the up or down buttons to set the heating trigger temperature.
To calibrate your register booster fans, turn on your heater and wait for
a few minutes until the probe temperature stabilizes. Set your heating
trigger to this number or lower.
To avoid confusion, we recommend disabling the heating trigger when
not using your heater. To disable it, hold the mode button for two
seconds. The display will show OF. We also recommend returning to the
temperature display mode once you finish adjusting your heating trigger.
17