AC Infinity AIRTAP Serie Manuel D'utilisation page 15

PROGRAMMING
COOLING TRIGGER
Use this mode to set the temperature trigger for your air conditioner.
Please note you are NOT setting your desired temperature.
In this mode, the fans will run if the probe temperature meets or falls
below the trigger's cold temperature setting. It will not run if the probe
temperature is above the trigger's cold temperature setting.
Press the up or down buttons to set the cooling trigger temperature. To
calibrate your register booster fans, turn on your AC and wait for a few
minutes until the probe temperature stabilizes. Set your cooling trigger to
this number or higher.
To avoid confusion, we recommend disabling the cooling trigger
when not using your AC. To disable it, hold the mode button for two
seconds. The display will show OF. We also recommend returning to the
temperature display mode once you finish adjusting your cooling trigger.
15