Stanley DUBUIS BGH700 Manuel D'utilisation page 20

English
Connect the hose with the cutting tool on the
rotating coupler of the group
Press the button ON/OFF tool. The 3 LED
light up (see LED INDICATIONS).
Put the cable to cut between the blades (see tool instruction manual).
In case of effort of cutting too important, the safety valve will stop the group at the reached
maximal pressure, to protect the group of overpressure. Repeat the cutting at 90° to the
previous cut.
CAUTION: PLEASE, DO NOT PUT YOUR FIN-GERS BETWEEN BLADES. RISK OF
GRAVE CUTS.
Press the release trigger to retract the blade.
PERFORM OTHER CUTTINGS IN THE SAME WAY.
BEFORE DISCONNECTING THE HOSE, PRESS THE RELEASE TRIGGER
0215 - BGH700 - 20
Slide the battery all the way into the
tool until lock clicks.
DO NOT USE THIS TOOL ON LIVE CABLES
USING IN CUTTING
Switch to the cut mode.
This mode allows stopping the group as soon as the cup is made without
taking into account a necessary specific pressure
If necessary, press the manual emergency
pressure relief
Connect the remote control if necessary