Stanley DUBUIS BGH700 Manuel D'utilisation page 19

USING IN CRIMPING
Connect the hose with the crimping tool on the
rotating coupler of the group
Press the button ON/OFF tool. The 3 LED
light up (see LED INDICATIONS).
Put the connector with the cable inserted between the two dies (see tool instruction
manual).
Press the crimping trigger up to automatic stop of the tool. The 3 LED light up
(see LED INDICATIONS).
CAUTION: THE DIES TIGHTEN VERY TIGHTLY. DO NOT SLIDE YOUR FIN-
GERS IN THE DIES PROFILE.
Press the release trigger to retract the piston.
Remove the crimping connector.
PERFORM OTHER CRIMPINGS IN THE SAME WAY.
BEFORE DISCONNECTING THE HOSE, PRESS THE RELEASE TRIGGER
0215 - BGH700 - 19
Slide the battery all the way into the
tool until lock clicks.
Switch to the crimp mode.
This mode allows verifying the pressure build-up of the group up to the
pre-set value.
The engine stops automatically and indicates "good crimping" (see LED
indication). A stop of the group before reaching this pressure will result in
a "bad crimping" (see LED indication)
Connect the remote control if necessary
If necessary, press the manual emergency
pressure relief
English