Bosch BBHF214G Mode D'emploi page 43

12
Fig.
Remove the hand-held cordless vacuum cleaner
from the hand stick.
Using the release button, unlock the dust container
and remove it from the motor unit.
13
Fig.
Take the filter unit out of the dust container.
Empty the dust container.
14
Fig.
Remove any dirt which may have been lodged under-
neath the container ejector opening.
a) Insert the filter unit into the dust container, making
sure it is correctly seated
b) Insert the dust container in the appliance, so that it
'clicks' audibly into place
!
Caution: If you notice any resistance when inserting
the dust container, check that the filter is complete
and that the filter unit and dust container are correct-
ly seated.
Cleaning the filter
The outer filter unit and filter cartridge should be clea-
ned at regular intervals in order to ensure optimum
operation of the vacuum cleaner.
!
Caution: The filter can only be cleaned if the appli-
ance is switched off.
Never vacuum without the outer filter unit and its
fitted filter cartridge.
15
Fig. Cleaning the outer filter unit
Switch off the appliance.
Remove the hand-held cordless vacuum cleaner
from the hand stick.
Using the release button, unlock the dust container
and remove it from the motor unit.
Take the filter unit out of the dust container.
a) It is usually sufficient to lightly shake or tap out the
whole filter unit when the dust container is emptied in
order to dislodge any particles of dirt.
b) If this is not sufficient, you can use a dry cloth to remo-
ve dirt particles from the surface.
16
Fig. Cleaning the filter cartridge
a) Remove the filter cartridge from the filter unit.
b) Firstly, clean the filter cartridge by tapping out the dirt.
c) Pull out the foam filter from the motor protection and
rinse separately.
Allow the foam filter and motor protection filter to
dry completely (approx. 24 hours)
After fitting the foam filter, insert the filter unit into the
dust container.
New filters can be obtained from our after-sales ser-
vice, if required.
7
Fig.
11
Fig.
7
Fig.
12
Fig.
Cleaning the floor nozzle
Before carrying out any maintenance, switch off the
vacuum cleaner and disconnect it from the charging
cable.
17
Fig.
Use the release button to release the brush roller
and pull it sideways out of the floor nozzle.
Using the groove provided, cut through threads and
hairs wound round the rollers with scissors.
Push the brush roller in sideways along the guide rod
in the floor tool and lock in place using the release
button.
!
Caution: The floor nozzle must only be put into
operation with the brush roller fitted.
!
Caution:
Floor nozzles are subject to a certain amount of
wear, depending on the type of hard floors you have
(e.g. rough, rustic tiles). You must therefore check
the underside of the floor tool at regular intervals.
Worn undersides of floor nozzles may have sharp
edges that can damage delicate hard floors, such as
parquet or linoleum. The manufacturer does not ac-
cept any responsibility for damage caused by worn
floor tools.
Care
Before cleaning the hand stick vacuum cleaner or hand-
held cordless vacuum cleaner, it must be switched off
and disconnected from the charging cable. The vacuum
cleaner and accessories can be cleaned using a stan-
dard commercially-available plastic cleaner.
!
Caution: Do not use abrasive materials, glass-
cleaning agents or all-purpose cleaning products.
Never immerse the vacuum cleaner in water.
Subject to technical modifications.
* Depending on model
41