Publicité
Les langues disponibles
Les langues disponibles
EN
4.5 - Replacing led
Switch-off the power supply. Open the cover as shown on
paragraph 4.3.
By using a screwdriver, release the bottom screw of the cover (Fig.
18a). Remove the mask and pull out the led band (Fig.18b).
4.6 - Electrical connections
WARNING - Before making the connections, ensure that the control unit is not powered up.
POWER SUPPLY CONNECTIONS
L
N
M2
SBS
26
Power supply 230 Vac 50-60 Hz
Earth
Power supply neutral 230 Vac 50-60 Hz
M1
M1
M2
Disconnect the plug connector (Fig.19a).
Connect the new led stripe and insert them into the mask.
Insert the mask by placing first the seal side and then fastening it
with the screw (Fig.19b).
M2
M1
PH1
TX
2
1
T2A
N
L
PH1
RX
Publicité
