Dogtra 1900S WETLANDS Manuel Du Propriétaire page 13

10. Using the Test Light
1. Turn on the receiver by pressing the on/off button. The
indicator light will come on for a moment then blink
once every 4 seconds, showing that the receiver is ready
to use (the receiver needs to be charged if the indicator
light is red).
2. Turn the transmitter on by holding down the on/off
button on the right side of the transmitter. The LED will
blink every 4 seconds and the LCD screen will show the
remaining battery life.
3. Place the test light, included in the package contents,
on the contact points as shown in the diagram.
4. Watch the test light as you press the Nick button on the
transmitter. It should light up for just a moment. The
higher the intensity, the brighter the test light will be.
5. Watch the test light as you press the Constant button on
the transmitter. It should light up as long as the button
is pressed. However, as a safety feature, the receiver
will automatically stop the stimulation if the Constant
button is pressed for 12 seconds or longer.
22
6. Turn the Rheostat Dial on the transmitter clockwise
and then counterclockwise. The test light should glow
brighter with higher levels of stimulation and dimmer
with lower levels.
Note: The test light may not be visible if the intensity level
is set below level ten.
23