Télécharger Imprimer la page

ETNA OM990RVS Mode D'emploi page 60

Publicité

Les langues disponibles

Les langues disponibles

CLEANING
Cleaning the outside
Cleaning the inside
Removing the oven door
N
A
EN 12
Clean the display and the oven door with a cleaning product for glass
and a soft cloth. Do not use abrasive detergents or scouring powders.
• Remove the (telescopic) guides
• Clean the oven while still hot with a hot, soapy solution and a cloth.
• The grill element can be folded down to clean the top. Remove the
two securing screws on the front of the element and fold it down.
Warning
Switch the oven off when cleaning the inside. Allow the oven to cool
before components are removed and switch off the power supply
(remove plug from the outlet).
To clean the inside of the oven better you can remove the oven door.
• Open the oven door fully and turn the pawls (N) back as far as they
will go.
• Then close the door slowly so the pawls end up in the holder.
At approximately 15° (relative to the closed door position) lift the
door slightly upwards and lift it out of the two hinge holders.
• Use the reverse order to assemble the door. Insert the door at an
angle of 15° in the hinges on the front of the appliance and push
A
the door forwards and downwards so that the hinges slide into their
notches. Check to be sure the hinge notches are properly in place.
• Then open the door fully and turn the pawls back to their initial
position. Close the door slowly and check that it closes properly.
If the door does not open or close properly, make sure the hinge
notches are positioned correctly in the hinge holders.

Publicité

loading

Ce manuel est également adapté pour:

Om990rvs/e01