Dogtra YS600 Manuel Du Propriétaire page 8

COLLAR FITTING
The collar should be fitted so that the contact points
press firmly against the dog's skin. When properly
fitted, you should be able to fit a finger or two snugly in
between the contact points and your dog's skin. When
properly fitted, the receiver should not move on the
dog. The best location for the receiver is either side of
the dog's windpipe. A loose fit can allow the receiver to
move around on the dog's neck and cause irritation. If the
collar is too tight, the dog may have difficulty breathing.
Leaving the receiver in the same location on the dog's
neck for an extended period of time can cause skin
irritation. If the dog is to wear the collr for long periods,
occasionally reposition it every few hours so that the
contact points are moved to a different location on the
dog's neck and remove it after 8 hours of usage. Check
for skin irritation each time you use the unit.
12
Caution
Remove all other collars when using the No Bark
Collar. Additional collars or buckles that rub against
the No Bark Collar may inadvertently activate the
unit.
TROUBLESHOOTING GUIDE
1. My dog is not reacting to the collar.
- Make sure the receiver/collar is turned on.
- Be sure the strap is on the dog tight enough so that
both contact points are touching the dog's skin.
- The contact points may be too short for your dog's
thick or long coat. To place an order for longer contact
points, please contact Dogtra or a Dogtra dealer. If you
are already using longer contact points, you may need
to trim the hair on the dog's neck, so that both contact
points are touching the dog's skin.
- The intensity level may be too low for your dog. Increase
the stimulation until your dog responds.
2. My YS600 is not holding a charge.
- The charging pin may be damaged. A metal pin inside
the charging port should stand straight up and firm in
the center. If the pin is wobbly, broken or missing, you
will need to send the unit in to the repairs department.
- The charging port must be clean prior to charging, clean
out any dirt with a cotton swab and some rubbing
13