Dogtra YS600 Manuel Du Propriétaire page 6

THE PERSISTENT BARK INDICATOR
The Persistent Bark Indicator activates when the unit is
turned off and when there has been excessive barking.
1. Without excessive barking :
– The LED will glow red for 2 seconds when the unit is
turned off.
2. With excessive barking :
– The LED will blink green for 10 seconds when the unit is
turned off.
– Excessive barking may indicate that the stimulation
intensity level is set too low.
* Before increasing the stimulation intensity level, check
to see that the collar has a proper fit and both contact
points are touching your dog's neck.
8
TESTING THE YS600
1. Turn the dial to "T". The LED indicator will blink once
every 4 seconds.
2. Use the cap end of a ballpoint pen and scratch between
the contact points. The unit is working properly when it
vibrates twice.
* The sensor is set to high sensitivity on test mode to
activate more easily. The test mode will only produce a
non-stimulating vibration.
9