HOW TO USE THE ON/OFF &
INTENSITY DIAL
- The On/Off Intensity Dial is used to turn the No Bark
Collar on/off and to select the stimulation intensity
level.
- Set the dial to "
" to turn off the No Bark Collar.
•
- Set the dial to "P" for non-stimulating vibration only
mode.
- The No Bark Collar has stimulation levels 1 (lowest)
through 10 (highest). Each stimulation level begins with
a vibration and is followed by the stimulation.
- Set the dial to "T" to test the No Bark Collar. See Testing
the YS600 on page 9 to check if your unit is working
properly.
On/Off & Intensity Dial
•
P
1~10
T
NOTICE
When first using the YS600 No Bark Collar, it is
recommended to start at the lowest stimulation intensity
level. If your dog continues to bark, gradually increase
the stimulation intensity level. Closely monitor you dog's
reaction to find the right stimulation level for you dog.
6
Function
Power Off
Non-Stimulating Vibration
Stimulation Level
Test mode
THE LED INDICATOR
The LED indicator will flash for 1 second when the YS600
has been turned on, and every 4 seconds afterwards.
If your dog does not bark for over 30 seconds, the LED
indicator will turn off and the YS600 will go into a sleep
mode to conserve battery life. It will reactivate when your
dog barks and a vibration/correction needs to be made.
Before going into Sleep mode, the LED light flashes
green when the battery is fully charged and turns to
amber when the battery life is getting low. When the LED
indicator emits a blinking red light, the battery needs to
be recharged.
Battery
life
Fully charged
LED
window
On Working
Green
On Charging
Green
OPERATING MODES
1. Non-Stimulating High Performance Pager (P)
- The YS600 will vibrate twice when your dog barks.
It will not send a stimulation when set to "P".
2. Stimulation Intensity Levels (1-10)
- The YS600 will vibrate once followed by stimulation
when your dog barks.
* There is a 4 second delay between stimulation on levels
1-10 and vibration on P mode.
Medium charge
Needs charge
Yellow
Red
Red
Red
7