EIBENSTOCK ETR 230.1 Notice Originale page 24

specialist. Due to its design, the machine needs a minimum of care and
maintenance. However, the following points always have to be observed:
Always keep the power tool and the ventilation slots clean.

During work, please pay attention that no particles get inside the

machine.
In case of failure, a repair has to be carried out by an authorised service

workshop.
Environmental Protection
Raw material recycling instead of waste disposal
To avoid damages on transportation, the power tool has to be delivered in a
sturdy packing. Packaging as well as unit and accessories are made of
recyclable materials and can be disposed accordingly.
The tool's plastic components are marked according to their material, which
makes it possible to remove environmental friendly and differentiated because
of available collection facilities.
Noise Emission / Vibration
Measured values determined according to EN 62841-2-3.
Typically the A-weighted noise levels of the product are: Sound pressure level
L = 92 dB(A); Sound power level L
pA
Wear ear protectors!
Vibration total values (triax vector sum) determined according to EN 62841-2-3:
Surface grinding:
Vibration emission value
Uncertainty
Disk sanding:
Vibration emission value
Uncertainty
The vibration emission level given in this information sheet has been measured
in accordance with a standardized test given in EN 62841-2-3 and may be used
to compare one tool with another. It may be used for a preliminary assessment
Only for EU countries
Do not dispose of electric tools together with household
waste material! In observance of the European Directive
2012/19/EU on waste electrical and electronic equipment
and its implementation in accordance with national law,
electric tools that have reached the end of their life must be
collected separately and returned to an environmentally
compatible recycling facility.
a = 5,0 m/s
hAG
K = 1,5 m/s
AG
a = 5,4 m/s
hDS
K = 2,0 m/s
DS
= 103 dB(A). Uncertainty K
wA
2
2
2
2
24
= 3 dB.
pA