EIBENSTOCK ETR 230.1 Notice Originale page 18

Do not expose power tools to rain or wet conditions.
Water entering a power tool will increase the risk of electric
shock.
Cut-off machine safety warnings
The guard provided with the tool must be securely attached to the

power tool and positioned for maximum safety, so the least amount of
wheel is exposed towards the operator. Position yourself and
bystanders away from the plane of the rotating wheel. The guard helps
to protect operator from broken wheel fragments and accidental contact
with wheel.
Use only diamond cut-off wheels for your power tool. Just because an

accessory can be attached to your power tool, it does not assure safe
operation.
The rated speed of the accessory must be at least equal to the

maximum speed marked on the power tool. Accessories running faster
than their rated speed can break and fly apart.
Wheels must be used only for recommended applications. For

example: do not grind with the side of cut-off wheel. Abrasive cut-off
wheels are intended for peripheral grinding, side forces applied to these
wheels may cause them to shatter.
Always use undamaged wheel flanges that are of correct diameter for

your selected wheel. Proper wheel flanges support the wheel thus
reducing the possibility of wheel breakage.
Do not use worn down reinforced wheels from larger power tools.

Wheels intended for larger power tools are not suitable for the higher speed
of a smaller tool and may burst.
The outside diameter and the thickness of your accessory must be

within the capacity rating of your power tool. Incorrectly sized
accessories cannot be adequately guarded or controlled.
The arbour size of wheels and flanges must properly fit the spindle of

the power tool. Wheels and flanges with arbour holes that do not match
the mounting hardware of the power tool will run out of balance, vibrate
excessively and may cause loss of control.
Do not use damaged wheels. Before each use, inspect the wheels for

chips and cracks. If power tool or wheel is dropped, inspect for
damage or install an undamaged wheel. After inspecting and installing
the wheel, position yourself and bystanders away from the plane of
the rotating wheel and run the power tool at maximum no load speed
for one minute. Damaged wheels will normally break apart during this test
time.
Wear personal protective equipment. Depending on application, use

face shield, safety goggles or safety glasses. As appropriate, wear
dust mask, hearing protectors, gloves and shop apron capable of
stopping small abrasive or workpiece fragments. The eye protection
must be capable of stopping flying debris generated by various operations.
The dust mask or respirator must be capable of filtrating particles generated
18