Penguin FLORENCE Manuel D'instructions page 36

STEP #8
Set U-3 rafters over the middle of each panel with Bb-3 screws at the top and two (2) Z-3 screws over the
brackets on frame manually. Set U-3 rafter on each joint and use Z-3 screws manually. Do not use power drill. If
necessary, make a Pilot Hole 1/8".
STEP #9
Remove protective film from
two (2) sides of each panel
and make sure the top side
of the panel faces
sunlight. Insert and slide on
the top groove of the rafters
all the way to the end. Pp-3
should go first and last with
the Qq-3 panels in between.
the
36