Penguin FLORENCE Manuel D'instructions page 31

(minmum 6' in height), Spatula, Power drill, Tube of silicon, Drill bit 5/16" cement (according to surface)
BEFORE STARTING:
more than 1" per 8'. Avoid installing unit adjacent to trees or a sloped roof, as snow and ice may slide onto
the solarium and cause it to collapse. Please don't destroy boxes until completely assembled.
STEP #1
Decide the position of the door frames before assembly according to where you intend to slide the
door. At the front of the solarium, use frame D3 for the opening of the door and B3 for the direction of the
door when open. Ensure frames A-3 ½ are on the sides. Use E3 between frame ends and use two K3 joints
for corners. Look for the sticker on the door frame D3 that indicates which side is upward. (See sketch on
previous page)
NOTE:
When placing the door
frame opening,
make sure the inserts
on the frame are on the
inside and on the upper
half of the frame of the
solarium because the
door will be set on the
inside due to
clearance.
NOTE:
When sliding
the connectors, shake
the frame so that they
will slide easily. Do not
use tools to force. If
needed, clean the paint
with a file and make
sure the ends of the
frame and joints are not
bent or warped. If so,
use the needle-nosed
pliers to straighten or a
file to make them slide easily.
STEP #2
Ensure that you have a solid base, such as concrete or wooden deck, not slanted
31