Powerplus POWX1280 Mode D'emploi page 39

7 ASSEMBLY
Attention! Before performing any work on the equipment, pull the power
plug.
7.1 Eye shields/spark arrestors mounting (Fig. C)
▪
Before use, the eye shields/spark arrestors (1) must be fitted to the grinder.
▪
Remove both eye shields and metal mounting brackets from the packaging.
▪
Fit the 2 metal mounting brackets (2) on the front of the grinding wheel guard with the
bolts (a), washers and nuts.
▪
Position the shields over the two mounting brackets above the grinding wheels with the
flanges of the spark arrester facing away from you, fix with the bolts (b), washers and nut
provided.
7.2 Work rest mounting and adjustment (Fig. D)
▪
Take the work rests (4) out of the package, fix on the grinder with the knob (5) and nut
provided as shown in figure D.
▪
Make sure the gap (a) in the edge of the work rest is pointing towards the disc.
▪
The gap between the rests and the wheels should be checked before use.
▪
Measure the gap between the grinding wheel and the rests; this should be as small as
possible not greater than 2 mm, if not, loosen the two knobs on each of the rests, set the
correct gap and fully tighten.
▪
The gap must be maintained as the wheel wears.
7.3 Changing the grinding wheels (Fig. A & E)
▪
If you want to change the grinding wheel on the right side (Fig. E):
▪
Unscrew the rotary tool (8) by turning the locking ring (a) clockwise (reverse thread).
▪
Using a screwdriver, remove the screws (a) from the protective cover.
▪
Remove the protective cover (12).
▪
Unscrew the nut (b) from the shaft (c) using a 17 mm wrench.
▪
Hold the disc (d) firmly in one hand to create a suitable counterpressure.
▪
Remove the tension disc (e) and grinding, or buffing disc (d).
▪
Place the new grinding or buffing disc on the shaft (c).
▪
Push the tension disc (e) back onto the shaft (c).
▪
Screw the nut (b) back onto the shaft (c).
▪
Hold the disc (d) that you have just attached firmly in one hand to create a suitable
counterpressure.
▪
Re-tighten the nut (b).
▪
Refit the protective cover and fix it in place by tightening the screws (a).
▪
For the right side only (Fig. E): Screw the rotary tool (8) back onto the connecting thread
(b) of the appliance.
▪
To do this, push the square axle core (c) of the flexible shaft into the square hole on the
connecting thread.
▪
Turn the locking ring anticlockwise (reverse thread) to tighten it.
Never use the grinding or buffing disc without the protective cover!
Do not tighten the nut too much since the grinding disc could break.
Copyright © 2022 VARO
POWX1280
P a g e | 7
EN
www.varo.com