Publicité
Les langues disponibles
Les langues disponibles
Laundry tub drain system (view C)
The laundry tub requires a minimum carry-away capacity of
4.2 gal. (15.9 L) per minute.
The top of the laundry tub must be at least 23.5" (59.7 cm) above
the floor and no higher than 72" (183 cm) from the bottom of the
washer.
Floor drain system (view D)
The floor drain system requires a siphon break that may be
purchased separately. See "Tools and Parts."
The siphon break must be a minimum of 28" (71 cm) from the
bottom of the washer. Additional hoses might be needed.
The minimum carry-away capacity can be no less than 4.2 gal.
(15.9 L) per minute.
23.5 - 35"
(59.7 - 88.9 cm)
C
Connect Drain Hose
Proper connection of the drain hose will help protect your floors
from damage due to water leakage. To keep the drain hose from
coming off or leaking, it must be installed according to the
following instructions.
IMPORTANT: To ensure proper installation, this procedure must
be followed exactly.
For standpipe or laundry tub drain systems:
1. Check the drain hose to see that it is the proper length.
2. Install the U-shaped hose form to end of the drain hose to
create a hook-shaped end as shown.
A
A. Snap either end of the U-shaped hose form to the drain hose at the
point where the corrugation begins.
B. Bend drain hose over the form and snap into place.
8
All manuals and user guides at all-guides.com
D
B
3. Put hooked end of drain hose into laundry tub or standpipe.
See illustrations A and B.
If the washer faucets and the drain standpipe are recessed,
put the hooked end of the drain hose in the standpipe as
shown. See illustration C.
A
To keep drain water from going back into the washer:
Do not straighten hooked end of drain hose. Do not force
excess drain hose into standpipe. Hose should be secure,
but loose enough to provide a gap of air.
NOTE: To avoid siphoning, do not seal the drain hose to the
standpipe.
Do not lay excess drain hose in bottom of laundry tub.
Do not force excess drain hose back into the rear of the
washer.
For floor drain installation, see kit number required under
"Tools and Parts."
Connect the Inlet Hoses
There are two hoses provided with the machine. The hot water
hose is indicated with a red stripe running the length of the hose.
Insert new flat washers (supplied) into the straight hose fitting of
each inlet hose. Firmly seat the washers in the couplings.
Connect the inlet hoses to the water faucets
Make sure the washer basket is empty.
1. Attach the hose with the red stripe to the hot water faucet.
Screw on coupling by hand until it is seated on the washer.
2. Attach the other hose to the cold water faucet. Screw on
coupling by hand until it is seated on the washer.
3. Using pliers, tighten the couplings with an additional
two-thirds turn.
NOTE: Do not overtighten. Damage to the valves can result.
B
C
A
B
A. Coupling
B. Washer
Publicité
