Heco VICTA ELITE SUB 252A Mode D'emploi page 8

• LIGHTNING PROTECTION/PREVENTIVE MEASURES: If the device is not going to be used for a
prolonged period (e.g. when on holiday), it should be disconnected from the mains by removing
the plug. The device should also be disconnected from the mains in the event of a thunderstorm.
Doing this will prevent damage caused by lightning and overvoltage.
• MAINS CABLE: The mains cable must always be suitable for operation and it should only ever be
laid out in a manner that prevents it from being trodden on. It should not be pinched by objects
either, as this can damage the cable. When using plugs and power strips it must be ensured that
the cable is not kinked at the point where it emerges from the socket. Do not connect or remove
the mains cable with damp hands.
• The mains plug is used as the disconnecting device. Disconnecting devices shall remain readily
operable.
• OVERLOAD: Sockets, power strips and extension cables should not be overloaded. If an overload
occurs, there is a risk of electric shock and fire.
• SETTING UP: Please read the installation instructions.
• The device should only be positioned or mounted on a solid surface and not on moving base
frames, otherwise there is a risk of injury.
• Only use attachments/accessories specified by the manufacturer.
DAMAGE THAT MUST BE RECTIFIED BY A SPECIALIST:
If any of the following damage occurs, disconnect the device from the mains immediately and contact
a specialist to conduct the repair work:
• The device should not continue to be operated if there is visible damage to the mains cable. A
damaged cable should not be repaired, but must be replaced.
• Damage to the mains socket at the device.
• If moisture or water has entered the device or foreign objects have fallen into the device.
• If the device has fallen and the housing is damaged.
• If the device does not work properly, even though all of the information in the instruction manual
has been observed.
Only those subsequent alterations approved by the manufacturer may be conducted.
Only original spare parts should be used for repair.
After conducting any repairs the safety of device should be checked to ensure it is functioning
correctly and safely.
Repairs must always be conducted by qualified specialists, as you might otherwise be exposed to
dangerous high voltage levels or other hazards.
THE HECO VICTA ELITE SUB 252A ACTIVE SUBWOOFER
This subwoofer has been adapted to provide the best visual and acoustic match to the HECO VICTA
ELITE range of loudspeakers. However, it goes without saying that it may be combined with other
loudspeakers.
When connecting your loudspeaker, please make sure that everything has been switched off.
Furthermore, make sure that all loudspeaker cables are connected to the proper poles, i.e. the positive
pole for the output is connected to the positive pole for the input and the negative pole with the negative
pole. Please also refer to your receiver's/amplifier's and loudspeakers' instructions.
8