Publicité
Les langues disponibles
Les langues disponibles
• If performing new exterior installation, please follow Step 6
• If performing replacement installation or interior
recirculation, please skip Step 6 and continue to Step 7
STEP 6
Create Exterior Ventilation (New Installation Only)
• Choose one of the exterior venting methods shown on Page 10.
• Create the exterior ventilation hole.
• Insert exterior damper into exterior ventilation hole.
• Following recommendations and calculations specified on Pages 8 to 10, use new aluminum/metal ducting cut
specifically for the distance between the range hood damper and the exterior damper.
• Fasten all connections with sheet metal screws and tape all joints with certified aluminum or foil tape.
• Please check the building codes in your city to learn which tape product is recommended.
STEP 7
Preparations
NOTE: To avoid damage to your hood, prevent debris from entering the vent opening.
• Determine and mark the centre line on the ceiling or wall where the range hood will be installed.
IMPORTANT
When installing with internal recirculation function, unit must be placed 1.8 in. (48 mm) from
cabinet, to expose venting outlet (Fig #1). Refer to measurements provided on Page 7 and 9.
• Make sure there is proper clearance within the ceiling or wall for exhaust vent.
• Due to the weight and size of this unit, please make sure that the support system or framework
being used is stable and secure in the ceiling or wall.
• Put a thick, protective covering over counter top, cook top or range to protect from damage or dirt.
• Remove any hazardous objects around the area when installing.
CAUTION
If moving the cooking range is necessary to install the hood, turn OFF the power on an electric range at the main
electrical box. SHUT OFF THE GAS BEFORE MOVING A GAS RANGE
• Remove the two filters to allow access to the inside of the unit. (See Fig #2)
Installation
Fig #2
— 11 —
1.8 in.
(48 mm)
Internal recirculation
ONLY
Fig #1
Publicité
