Uline H-2293 Mode D'emploi page 2

WARNING: Wear eye protection when
completing step 2.
2. Using a 3/8" diameter masonry drill bit, drill four holes
2½" deep into the surface where marked.
(See Figure 2)
Figure 2
NOTE: For the anchor to function properly, the
hole must not be larger in diameter than the
anchor bolt.
3. Clean out debris and dust from inside the hole.
Fully insert the anchor bolts through the receptacle
mounting holes and into the drilled holes.
(See Figure 3)
Figure 3
PAGE 2 OF 9
ASSEMBLY CONTINUED
4. Tap down anchor bolts with a hammer. (See Figure 5)
ATTACHING LID
1. To attach the lid to receptacle base, start by
threading cable through one side of cable band.
(See Figure 6)
NOTE: Thread washer and nut onto anchor bolt.
Nut should be tightened halfway between end
of bolt and top of anchor sleeve. (See Figure 4)
Figure 4
Tightened
halfway
Figure 5
Figure 6
Too Too
Tight
Loose
Cable Band
Cable
0621 IH-2293