Timberwolf TZ3000H Manuel D'installation Et D'utilisation page 30

fi nishing
EN
6.4 optional NZ64 blower installation
WARNING
!
• All wiring should be done by a qualifi ed electrician and shall be in compliance with local codes and with the
current National Electric Code ANSI / NFPA No. 70-Current (in the United States), or, with the current C22.1
Canadian Electric Code (in Canada).
This appliance is supplied with one micro (pressure) switch and a thermally
activated switch.
note:
The blower on high will draw 3.0 amps using 120V or approximately
360 watts.
Ensure that the pressure switch actuating arm protrudes through the faceplate
when installed and moves freely.
The blower will only operate when the doors are fully closed.
High
MODULATE BLOWER TO SUIT HEAT OUTPUT
30
W415-2827 / 02.14.20
Bump
Medium Low