Madas EVQ-1 Mode D'emploi page 19

5.1 - CONNECTOR/ELECTRONIC BOARD REPLACEMENT
fig. 1
28
1
2
g. Loosen the 4 fastening screws (1) of the cover (2);
h. Remove the over (2) and loosen the cable gland (3) with a 22mm commercial spanner;
i. Loosen the screws of the main terminal board (31) and remove the existing electric wiring by extracting the cables from
the terminal board and cable gland (3);
j. Using an 8 mm socket spanner, loosen the fastening nut (28) and remove it together with the toothed washer (27);
k. Remove the connector/board (30) as shown in
wires that come out;
l. Wire the two wires coming out from the rear terminal board (32) of the new connector/board;
IMPORTANT: Being careful not to pinch the two cables, in the centre pin (29) insert: the new connector/board +
toothed washer (27) + nut (28). With an 8mm socket spanner, tighten the nut (28);
Proceed as specified in points c-f in section 3.2
g
j
Madas Technical Manual - 1|1.5d - REV. 1 of 10
30
27
33 31 29
. Loosen the screws from the rear terminal board (32) and remove the two
k
h
k
Sep 2020
th
19
3
19
4
i
l
EV(Q-R-S-T)-1-3-6
32
30