Sauder Cannery Bridge Serie Mode D'emploi page 8

Step 4
å
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into the
ENDS (A and B) until the shoulders of the SCREWS rest on
the surfaces of the ENDS.
å
NOTE: Do not overtighten the SCREWS.
å
Slide the MOLDINGS (M) onto the ENDS (A and B). Line up
the grooves in the MOLDINGS over the heads of the SCREWS
in the ENDS.
å
NOTE: If the MOLDING comes up off of the SCREWS, remove
it and slide it on again.
å
NOTE: The MOLDINGS should be centered on the ENDS.
Page 8
B
32S
420337
BLACK 9/16" FLAT HEAD SCREW
A
M
Shoulder
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
32S
(4 used in this step)
M
www.sauder.com/service