Sauder Cannery Bridge Serie Mode D'emploi page 19

Step 15
å
Carefully turn your unit over onto its front edges. Lay the BACK (F)
over your unit.
å
Make equal margins along the two short edges of the BACK (F)
and along the long edges of the BACK (F). Push on opposite
corners of your unit if needed to make it "square".
å
Fasten the BACK (F) to your unit using the NAILS (1N).
å
NOTE: A perforation has been provided for access through the
BACK. Carefully cut out the hole if needed.
NAIL
(18 used in this step)
www.sauder.com/service
1N
F
Printed information
will be on the
opposite surface.
420337
8
The perforation
should be here.
Page 19