Sauder Cannery Bridge Serie Mode D'emploi page 20

Step 16
1
D14
J
Groove
å
Insert the DRAWER SIDES (D14 and D15) at an angle
into the slot at each end of the DRAWER FRONT (J).
3
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
å
Fasten the DRAWER BACK (D151) to the DRAWER SIDES (D14 and D15). Use four BLACK 1-9/16"
FLAT HEAD SCREWS (30S).
å
NOTE: Be sure the DRAWER BOTTOM (D953) inserts into the groove of the DRAWER BACK (D151).
Page 20
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D15
D151
D14
D953
2
D14
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (D953 ) into the
grooves in the DRAWER SIDES (D14 and D15) and
DRAWER FRONT (J).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D15
420337
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
U n fi
n i s h
s u r
e d
f a c
e
D953
D15
J
30S
(4 used in this step)
www.sauder.com/service
9