Bosch 121401266 Notice Originale page 31

Deleting the memory
To delete the content of the memory, press button (4) [Func], so that the symbol ap-
pears on the display. Then briefly press the on/off button (5) [ ] to delete the displayed
measured value.
If the measuring tool is switched off during the memory function, the memory value
shown on the display will be deleted.
Adding/subtracting values
Measured values or end results can be added or subtracted.
Adding values
The following example describes the addition of areas:
Measure an area as described in the section on (see "Area measurement", page 29).
Press the button (6) [+]. The calculated area is shown on the display,
and symbol "+" flashes.
Press the measuring button (2) [ ] to start another area measure-
ment. Measure an area as described in the section on (see "Area
measurement", page 29).
Press button (6) [+] to calculate the sum. The end result is shown at
the bottom of the display.
To exit addition, press the button (4) [Func].
Subtracting values
To subtract values, press the button (3) [–]. The subsequent steps are the same as for
the section on adding values.
Changing the unit of measurement
The default unit of measurement is "m" (metres).
Bosch Power Tools
English | 31
1 609 92A 7L2 | (26.04.2022)