Publicité
Les langues disponibles
Les langues disponibles
5. Remove the protective skin from the screw covers. Slide or
snap the screw covers into the handle trim section.
Top Grille Panel
1. Grasp both ends of the top grille.
2. Push straight up; then pull straight out. Place the top grille
panel-side down on a soft working surface.
B
A. Top grille
B. Cabinet side trim
3. Remove one end cap by loosening the nuts with a ¹¹⁄₃₂" nut
driver and slide the end cap off.
A. Bottom rail
B. Nuts
4. Slide the backer panel into the top grille channel and reattach
the end cap.
A. Backer panel
All manuals and user guides at all-guides.com
A
B
C. End cap
D. Top rail
5. Replace the top grille in the cabinet side trims and pull the
panel down slightly to lock it into place.
B
A. Top grille
B. Cabinet side trim
Adjust Door
Door Swing Adjustment
1. Check that the refrigerator door can open freely. If the door
opens too wide, remove the door stop screw from the bottom
hinge with a Torx
®†
T15 screwdriver.
A. Door stop screw
2. Hold the door open to a position that is less than 90°.
3. Replace the door stop screw in the bottom hinge and tighten.
IMPORTANT: Do not place the door stop screw in the 130°
position on Overlay Series models. See "Handle and Door
Clearances."
A
A. 130°
B. 110° (Overlay series)
C. 90°
†®TORX is a registered trademark of Textron Innovations Inc.
A
B
A
B
C
21
Publicité
