Publicité
Les langues disponibles
Les langues disponibles
Any kind of food (meat, fish, legumes, eggs, rice, vegetables, etc.) can be cooked on the glass ceramic coking tops,
providing suitable pans are used.
Hotplates: Switch on the main switch installed above the appliance. Turn the control knob corresponding to the
hotplate from position "0" to the degree of coking desired, between 1 and 6. The light comes on, as son as the power
supply is on. It is advisable to turn on the hotplate at maximum temperature and, as soon as this is reached, turn the
control knob to the level desired. To turn off the hotplate, turn the knob back into position "0".
Oven: Turn the temperature regulator to the right, to the temperature desired. The temperatures correspond to the
following table:
.
Temperature
from °C
to
°C
-
If more heating is required, turn the temperature regulator towards the degrees desired.
-
If less heating is required, turn the temperature regulator towards the degrees desired.
Switch on the main switch installed above the appliance. Turn the control knob corresponding to the hotplate from
position "0" to the degree of heating desired, between 1 and 6. The light comes on, as son as the power supply is on.
The green light indicates the presence of electrical tension. To turn off the hotplate, turn the knob back into position
"0". The hotplates are made up of a nucleus and a crown.
Turning the knob, as indicated above, only the nucleus of the hotplate comes on; turning the knob beyond position "6",
the crown also comes on and the temperature can, once again be regulated from pos. "1" to pos. "6".
Attention! During cleaning, do not wash the external parts of the appliance with direct sprays of water or with
high pressure.
After every use, clean the appliance thoroughly. Daily cleaning after switching off the appliance ensures the perfect
functioning and long life of the appliance.
Before starting to clean the appliance, disconnect the power supply. The parts in steel must be washed with hot water
and neutral detergent, then rinsed thoroughly in order to eliminate all traces of detergent; after which, dried with a dry
cloth. Do not use abrasive or corrosive detergents.
Cleaning the crystal
The crystal must be cleaned with degreasing liquids, acids containing vinegar and lemon, suitable for cleaning ceramic
and crystal. It is advisable to carry out this operation when the crystal is not completely cold, so that spilled food,
burned grease, etc. can be softened using a damp cloth and removed whilst still warm with an ordinary scraper, in order
to avoid damaging the crystal surface.
Do not use abrasive or corrosive detergents.
PROCEDURE TO FOLLOW IF THE APPLIANCE IS NOT GOING TO BE USED FOR
Clean and dry the appliance carefully according to the instructions. Disconnect the power supply.
PROCEDURE TO FOLLOW IN THE EVENT OF A BREAKDOWN
In the event of breakdown, turn off the appliance, disconnect the power supply by using the device situated above the
appliance and notify the after sales service.
GB
IT
TURNING ON
50
65
100
75
95
130
TURNING ON GLASS CERAMIC
CLEANING AND MAINTENANCE
SOME TIME
22
IE
CH
150
195
245
180
225
270
250
275
Publicité
