Installing Bed Extension On Leg; Maintenance And Inspection - Jet JWL-2442-M Mode D'emploi

Top surfaces and inside ways must be flush to allow
smooth movement of tailstock.
Slide tailstock over joint where beds meet, so that
clamping nut is centred over joint. Lock tailstock clamping
handle; this will align the beds. (Fig 37).
Tighten screws in extension bed.
7.8 Install bed extension (# 6294905E) on leg
For outboard turning, move the headstock to opposite
end of lathe (Fig 38).
Fig 36
Fig 37
To accommodate large work pieces, you can mount the
bed extension to the lower set of holes, and mount an
extension post (included with # 6294905E) to the tool rest
base.
The machined surfaces of bed end and leg must be
aligned flush.
Use a straight edge to check (Fig 39).
Install bed extension in the same manner as described in
chapter 7.7
For larger outboard work, a heavy outboard turning stand
is available (# 708349)

8. Maintenance and inspection

General notes:
Maintenance, cleaning and repair work may only be
carried out after the machine is protected against
Fig 38
Fig 39