Télécharger Imprimer la page

Elica EHI648BL Prescriptions De Montage Et Mode D'emploi page 6

Masquer les pouces Voir aussi pour EHI648BL:

Publicité

Hood installation height above cooktop is the users
preference.
CAUTION:
FOR GAS RANGES
INSTALLATION: MOUNT THIS HOOD SO
THAT THE BOTTOM EDGE IS AT 30" (76,2
CM) ABOVE THE COOKING SURFACE.
FOR ELECTRIC RANGES INSTALLATION:
MOUNT THIS HOOD SO THAT THE
BOTTOM EDGE IS NOT LESS THAN 30"
(76,2 CM) ABOVE THE COOKING
SURFACE.
HOUSEHOLD USE. PLEASE, READ
INSTALLATION MANUAL FOR SPECIFIC
APPLICATION.
If the instructions for installation for the
gas hob specify a greater distance, this
must be adhered to.
Check your ceiling height and the hood
height maximum before you select your
hood.
Consult last pages of this manual for installation
instruction and electrical connection steps.
Operation
ON/OFF light button
Press to turn the cooktop light on or off.
"BOOST" speed selection key
1st push: to activate the intensive suction
speed "BOOST", timed for 7 minutes
Note: after 7 minutes, the hood will return
to the previously set suction speed
2nd push ("BOOST" activated): to exit
the function and return to the speed
previously set.
Note: the speed key previously set
remains lit during BOOST operation.
Speed selection key 3
Push to activate the high speed (suction
power)
Speed selection key 2
Push to activate the
(suction power)
average speed
6
Speed selection key 1
Push to enable the low speed (suction
power)
Power button
Push to switch on the hood and enable
speed selection;
if pushed while the motor is running, the
latter will stop
Note: if no function is activated within 10
seconds, the hood turns off.
Filter Saturation indicator lights
The hood signals at regular intervals that the filters must be
serviced.
Keys
and
service the grease filter.
Keys
and
service the odour filter.
Note: The filter saturation warning signal is visible within
the first 10 seconds after the hood is switched on.
Reset filter saturation indicator:
Press and hold the keys
The keys will flash quickly to confirm that reset has been
completed
Activation of filter saturation indicators
Note: this operation must be performed with the hood off.
- Grease filter
1st press and holding of keys
the keys light up flashing very slowly, indicating that the
grease filter indicator can be activated
Note: Push the keys
deactivate
lit and flashing very slowly:
lit and flashing quickly:
and
and
to activate and
to

Publicité

loading

Ce manuel est également adapté pour:

Ehi648whHaiku islandEhi648ssEhi613ssPrf0157462