Saba HC689IX Manuel D'utilisation page 24

rotations to loosen it. You can now rotate the
adjusting nut (as shown in diagram below) to
raise or lower the height of the door. Once the
door is set to your desired position, then tighten
the locking nut by rotating it anti-clockwise.
Fixed shaft
Not level
Leveling feet
Locking nut
GB
When the fridge door is low:
Open the door, use a wrench to rotate the
adjusting nut anti-clockwise to raise the height
of the door. Once the doors are aligned, then
tighten the locking nut by rotating it anti-
clockwise.
When the fridge door is high:
Open the door, use a wrench to rotate the
adjusting nut clockwise to lower the height of the
door. Once the doors are aligned, then tighten
the locking nut by rotating it anti-clockwise.
16
Adjusting nut
Right Wrench
.
If «OK» is not displayed, the average
temperature in this area will be very high.
You ought to adjust the thermostat to a
colder setting.
For every modification of your thermostat, you
are supposed to wait for the stabilization of the
temperature inside the unit before proceeding,
if necessary, to a new setting. Do change the
position of the thermostat gradually and wait
at least 12 hours before re-checking.
For every modification of your thermostat, you
are supposed to wait for the stabilization of the
temperature inside the unit before proceeding,
if necessary, to a new setting. Do change the
position of the thermostat gradually and wait
at least 12 hours before re-checking.
NOTE: after charging the device for fresh food
or after repeated or prolonged door openings,
it is normal that the inscription «OK» does not
appear in the temperature indicator. Wait at least
12 hours before readjusting the thermostat.
GB
17