Triangle BOREA BR02 Mode D'emploi page 19

EN
Positioning the BRA1 on a speaker
The BRA1 fits perfectly on the BOREA 03, 07, 08 and 09 speakers. In this configuration, the BRA1
pointing towards your ceiling, will add an effect of space when playing films or TV programs with
this kind of sound format.
It is recommended to set the adjustment switch, located on the terminal block, to the position B.
This position increases the high frequency of the speaker and thus compensates for the loss of
directivity associated with its orientation.
A B
Positioning the BRA1 on a wall
The BRA1 can be installed on the wall to be used as an effect channel. Using the template, you
can easily determine the drilling points on your wall. Use screws and wall anchors adapted to your
wallboard. The diameter of the screws must not exceed 4mm.
It is recommended to set the adjustment switch, located on the terminal block, to the position A.
This position corresponds to a normal high-frequency level of the speaker in direct transmission.
A
B
19