S&P ARTIC-405 CN TC Manuel D'utilisation page 9

TIMER OFF
Using the control buttons on the timer, it is possible to program the fan stops auto-
matically after 1h-9h.
TIMER ON
Using the control buttons on the timer, it is possible to program the fan starts auto-
matically after 1h-9h.
REMOTE CONTROL
• Insert the 2 batteries type AAA in the remote control. (not included)
• Maximum distance to the receiver up to about 3 meters provided no there are no obstacles
in the way that could distort the signal.
• Pls handle with care do not expose to humidity or a long time periods in direct sunlight.
INCLINACIÓN DEL CABEZAL
The ARTIC-CN fans have a multi-swinging head. To lean it you only have to press over the fan
adjusting it to the desired angle (Fig. 3).
MAINTENANCE
Before beginning any cleaning or maintenance operation on the appliance unplug it from
the mains supply.
The ARTIC-CN fans do not need any special maintenance. To take out the propeller, you must
follow the fi tting instructions in reverse order. The propeller can be cleaned using warm wa-
ter with a small quantity of a mild detergent. Clean the outside of the fan with a moistened
cloth. Do not sink the fan. Do not use neither abrasive products nor solvents. Before mounting
it again, be sure that all the components are completely dry.
Important: Make sure the fan is disconnected from power supply before removing the protection.
Operating example
By selecting this sequence, the fan will run at 5 speed and with oscilla-
tion during the hours that have been scheduled.
Operating example
7 hours after programming, the fan always
starts automatically at the defi ned speed and with oscillation.
9