Hilti UD 16 Mode D'emploi page 13

Technical data
For details of the rated voltage, current, frequency and/or input power, please refer to the power
tool's country-specific type identification plate.
When powered by a generator or transformer, the generator or transformer's power output must
be at least twice the rated input power shown on the rating plate of the power tool. The operating
voltage of the transformer or generator must always be within +5% and -15% of the rated voltage of
the power tool.
Product generation
Weight
Using extension cords
WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord or extension cord if
damaged while working. Disconnect the supply cord plug from the power outlet.
▶
Check the appliance's supply cord at regular intervals and have it replaced by a qualified specialist
if found to be damaged.
• Use only extension cords of a type approved for the application and with conductors of adequate
gauge (cross section). The power tool may otherwise suffer a drop in performance and the extension
cord may overheat.
• Check the extension cord for damage at regular intervals.
• Replace damaged extension cords.
• When working outdoors, use only extension cords that are approved and correspondingly marked
for this application.
Recommended minimum conductor cross-section and maximum power-cord length for 120V
supply voltage
Cord
Power-cord length UD 16
Power-cord length UD 30
Operation
Preparations at the workplace
CAUTION
Risk of injury! Inadvertent starting of the product.
▶
Unplug the supply cord before making adjustments to the power tool or before changing
accessories.
Observe the safety instructions and warnings in this documentation and on the product.
Fitting and adjusting the side handle
1.Release the side handle clamping band by turning the handle grip.
With the UD 16, it is essential to ensure that the sleeve is fitted in the grip of the side
handle.
2.Slide the side handle clamping band over the tool holder from the front and into the recess provided.
*273764*
AWG 16
50 ft
50 ft
2
273764
UD 16
01
2.6 kg
(5.7 lb)
AWG 14
100 ft
125 ft
UD 30
01
2.5 kg
(5.5 lb)
AWG 12
150 ft
200 ft
6