Publicité
Les langues disponibles
Les langues disponibles
FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL
THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE
INSTRUCTION MANUAL.
ATTACHING THE DUST BAG
1. Attach the dust spout (A) Fig. 3 to the dust port (B).
2. Depress the spring clips (C) Fig. 3 of dust bag (D) and clip the dust bag (D) over the rib of the dust spout (A).
MOVING THE CUTTINGHEAD TO THE UP POSITION
Push down on the handle (B) Fig. 4. Pull out the cutting-head lockpin (A) and move the cuttinghead to the up position.
C
D
Fig. 3
NOTE: The tension of the cuttinghead return spring has been adjusted at the factory so that the cuttinghead returns to the "up"
position after a cut has been made. If the head fails to return properly, please take the tool to your nearest authorized service
center for service.
MOVING THE TABLE TO THE 0° CUT-OFF POSITION
1.
Rotate the locking knob (A) Fig. 5 counter-clockwise as far as it will go. Depress the lever (B) and rotate the table
(C) to the 0° straight cut-off position, release the lever (B), and tighten the locking knob (A).
NOTE: This saw incorporates a new slotted plate design feature (D) Fig. 6 with location adjustment screws (E) for
fine-adjusting the cutting angle.
2.
For proper operation and adjustment of the table, refer to sections, "ROTATING TABLE FOR MITER CUTTING",
and "ADJUSTING SLIDING FIT BETWEEN MOVABLE TABLE AND BASE.
A
ASSEMBLY
ASSEMBLY TOOLS REQUIRED
2mm Hex Wrench (Supplied)
Open-end 7/16" Wrench (Supplied)
ASSEMBLY TIME ESTIMATE
Assembly for this machine takes less than 30 minutes.
A
B
B
C
Fig. 5
Wrench (Supplied)
B
Fig. 4
9
A
E
D
E
Fig. 6
Publicité
