Publicité
Les langues disponibles
Les langues disponibles
English
Loosen and remove the screw from the throttle wire
holder. (Fig. 6)
Connect the terminals of the stop cords coming out
from the engine and shaft. (Fig. 7)
Hook the throttle wire end on the throttle of the
carburetor.
Make sure that the throttle trigger shown in Fig. 18
has returned to the starting position.
Put the throttle outer end into the groove, and then
cover it with the throttle wire holder and fi x the holder
with the screw. (Fig. 8)
Then, install the cleaner cover. (Fig. 9)
8
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fix the protection tube which the stop cords and
throttle wire are passing through, on the pipe with
the hip pad. Then, as shown in the fi gure, fi x the
protection tube on the pipe and handle with the
bands in the bag.
After fi xing, cut off the extra part of the band not to
obstruct the operation. (Fig. 4)
NOTE
If the protection tube is set apart from the handle
or pipe, it will be caught by something during
operation and it may cause serious injury.
Do not set the protection tube apart from the
handle or pipe.
Some models may come with the parts pre-installed.
Installation of blade guard (Fig. 10)
The guard bracket already mounted to the drive
shaft tube.
Attach the gear case cover with the three screws.
Install the blade guard on drive shaft tube against
angle transmission (5). Tighten the guard bracket
fi rmly so that the blade guard does not swing or
move down during operation.
5
CAUTION
The blade guard must be in place during
operation.
If the blade guard is not in place, there is a
possibility of serious injury.
Blade guards are equipped with sharp line limiter. Be
careful with handling it.
NOTE
○ When attaching the guard extension to the blade
guard, the sharp line limiter must be removed
from the blade guard.
Fig. 10
Publicité
