Tanaka TCG 31EBS Instructions De Sécurité Et Mode D'emploi page 16

English
Nylon head
Nylon line replacement
○ Remove the cutting body cap by pushing inward
the locking tabs on the side of the nylon head
(Fig. 37). Take out the spool, hook the new nylon
line into the hole of the spool, then wind it around
the spool in two stages (Fig. 38).
When the nylon line has been wound around the
spool, temporarily fasten it in the opening of the
spool at about 4˝ (10 cm) from the end. (Fig. 39)
Then thread the nylon line through the hole on
the side of the nylon head and place the cutting
body cap in reverse order of the cap removal.
Pull the right and left nylon lines until they are
secured about 4-11/32˝ – 5-1/2˝ (11–14 cm) from
the end. (Fig. 42)
4˝ (10 cm)
16
Fig. 37
Fig. 38
Fig. 39
4-11/32˝–5-1/2˝
(11–14 cm)
NOTE
○ The nylon head is designed for nylon lines with
an outer diameter of 0.1˝ (2.5 mm). Do not use
nylon lines with a diff erent outer diameter.
○ Make sure that the right and left nylon lines are
of equal length since vibrations will otherwise
increase.
Maintenance schedule
Below you will fi nd some general maintenance
instructions. For further information please contact
your Tanaka dealer.
Fig. 40
Fig. 41
4-11/32˝–5-1/2˝
(11–14 cm)
Fig. 42