Olympus PPO-E04 Mode D'emploi page 20

7 Loading the Camera and Lens
The following description is applicable when the ZUIKO DIGITAL ED 7-14mm lens is used.
After installing the lens on the camera and attaching the zoom gear provided with the PER-E02 extension ring,
insert the camera into the PT-E series case on which the PER-E02 extension ring and PPO-E04 are mounted.
Screw the camera table provided with the PT-E
series case firmly into the bottom of the cam-
era.
Mode dial knob
oom dial
Camera table lock lever
Lift the PT- E series case's power switch dial,
mode dial knob and zoom dial, and turn the
case's camera table lock lever counterclock-
wise to release the lock. Refer to the PT-E
series case's instruction manual for instructions
of how to attach the hot shoe cable for the
flash.
Power switch dial
E-8
Remove the eyecup from the camera's viewfind-
er. If a lens cap or filter is attached to the lens or
the strap is attached to the camera, remove them
as well.
Confirm that the camera's power switch is OFF.
Align the "10 mm" zoom position with the zoom
index of the lens and, while pulling out the
zoom dial of the PT-E series case further, place
the camera table (with camera attached) on the
camera table mount on the inner side of the
front lid of the PT-E series case.
ull out the zoom
dial further.
ENU