Olympus PPO-E04 Mode D'emploi page 18

2) When the PPO-E04 is combined with the PER-E02 Extension Ring
(When using the ZUIKO DIGITAL ED 7-14mm lens)
CAUTION:･ When the PPO-E04 and PER-E02 extension ring are removed from the PT-E series case,
water drops on the O-rings may splash on the lens or camera. If this happens, wipe the water
drops away from the lens and camera with a dry cloth.
･ Make sure that all of the parts are completely dry before dismounting.
If any water is on the product, wipe it completely away and
make sure that the product is dry.
Holding the PT-E series case firmly with one hand, loosen the
PPO-E04 from the PER-E02 extension ring by turning the
PPO-E04 about 90 degrees counterclockwise. If the PPO-E04
is screwed in too tight, wrap it with a piece of rubber or other
slip-resistant material.
After loosening the PPO-E04, position it so that its lens
points down and turn it further counterclockwise until it sepa-
rates from the extension ring. Be careful not to drop the
PPO-E04, PER-E02 extension ring or PT-E series case.
Holding the PT-E series case firmly with one hand, loosen the
PER-E02 by turning it about 90 degrees counterclockwise. If the
PER-E02 is screwed in too tight, wrap it with a piece of rubber or
other slip-resistant material.
After loosening the PER-E02, point its lens down and turn it
further counterclockwise until it is separated from the PT-E
series case. Be careful not to drop the PER-E02 or PT-E.
E-6