Installation
What's in the Box
Make sure all the following items are included in the packaging. If any item is damaged or missing, contact your dealer.
● Microwave Oven Body x 1
● Roller Ring x 1
● Glass Tray x 1
● Bake Plate x 1
● Air Fry Kit
● User Manual
Before Installation
1. Make sure that all the packing materials are removed from the oven cavity.
2. Check the oven for any damage, such has misaligned or bent door, damaged door seals and sealing surface, broken or
loose door hinges and latches and dents inside the cavity or on the door. If there is any damage, do not operate the
oven and contact qualified service personnel.
3. This microwave oven must be placed on a flat, stable surface to hold its weight and the heaviest food likely to be
cooked in the oven.
4. Do not place the oven where heat, moisture, or high humidity are generated, or near combustible materials.
5. The oven must have sufficient airflow. Do not cover or block any openings on the oven. Do not remove feet on which
oven stands.
6. Do not operate the oven without glass tray, roller support, and shaft in their proper positions.
7. Make sure that the power supply cord is in good condition and does not run under the oven or over any hot or sharp
surface.
8. The electrical outlet or circuit breaker must be accessible to disconnect power in an emergency.
Microwave Oven Installation
Cutout dimensions and clearances
Overhang and surrounding cabinet material requirements: If installing near a ceiling or directly under the
countertop and the area around the vent exhaust, use a noncombustible material or a combustible material having a
minimum temperature rating of 194°F(90°C). Minimum distance from the top of the microwave cutout to an overhead
noncombustible surface is 1".
WARNING: FIRE, EXPLOSION, BURN INJURY, CARBON MONOXIDE POISONING
● The cooking appliance must be completely separated and/or sealed from other air moving or air
consuming devices such as, but not limited to, furnaces, microwave ovens, clothes dryers, cooling fans
and doors or drawers in common cabinets. Failure to do so will affect the appliance(s) combustion air
supply by creating either a negative or positive draft.
● NEGATIVE DRAFT caused by air moving appliances may draw the top burner flame down into or
toward the cooktop resulting in cooktop damage, burn hazard, explosion possibility and/or carbon
monoxide buildup.
● POSITIVE DRAFT may blow out the top burner flame during use resulting in an explosion and/or fire
hazard and/or injury to the occupants of the vehicle.
● DO NOT operate the appliance in excessive windy conditions as this may cause a negative or positive
draft.
● Warranty Manual
NOTE: Trim Kit Sold Separately
● One-Piece Trim Kit (Sold Separately):
● FMAML09-SS-TK (2023050377)
● FMAML09-BL-TK (2023050378)
- 6 -
CCD-0008961 Rev: 06-27-24