Publicité
Les langues disponibles
Les langues disponibles
1. Insert the battery (6) on the groove and slip it all the way
until you hear a "click" noise from the lock/unlock
button (7). At this point, the battery is locked in place;
2. To remove the battery, press the lock/unlock button and
pull out the battery.
Use VITO 20V lithium-ion batteries.
1. Place the battery in the charger in the same way as you
would place it in the appliance;
2. Plug the charger into the socket and let it charge.
Sometimes at the end of charging, both the battery and the
charger can be hot, which doesn't mean they malfunction.
Let the battery cool down before putting it in the cordless
air compressor.
1. Loosen the air hose nut (2) (but do not remove the nut);
2. Insert the hose thread into the connector;
3. Retighten the nut.
Remove the battery before fitting or changing accessories.
1. After raising the air chuck lever, insert the accessory
suitable for the work to be performed;
2. Lower the lever to lock the accessory in place;
3. To remove the accessory, lift the lever and remove it.
When operating the cordless air compressor, you must
consider some use procedures:
▪ Hold the appliance with both hands;
▪ This power tool was not designed for continuous
operation. It can be used continuously for a maximum of
6 minutes;
▪ If the appliance overheats, remove the battery and allow
it to cool down before using it again;
▪ Wear ear plugs while operating the cordless air
compressor. Exposure to noise can cause hearing loss;
▪ If the air hose is not connected to any object, the display
will show "0";
▪ Switch off the cordless air compressor immediately if
any of the following problems occur:
- Grease leakage through the ventilation slots;
- Damage to the cordless air compressor housing;
- Damage to the "ON/OFF" switch;
- If you sense smoke or burning smell.
You can choose between two pressure measurement units:
bar or psi.
To select which one you want, simply press the "ON/OFF"
switch (10), with the display (8) on.
Press and hold the "+" (11) or "-" (9) push-button until the
display starts flashing.
Then press the "+" or "-" button to set the desired pressure.
Once the set pressure appears on the display, do not press
any button. After about 3 seconds, the new pressure is set.
1. Press the "ON/OFF switch" (10);
2. Set the desired pressure;
3. Insert the suitable accessory for the task to be
performed;
4. Connect the air hose and adaptors to the object to be
inflated;
5. Press the trigger (3) until the appliance stops inflating;
6. Disconnect the accessory from the object by pulling it.
The cordless air compressor cuts-out automatically
when preset pressure has been reached.
(15) - For inflating pool floats or similar.
(16 and 17) - Universal adaptor for inflating balloons or
similar.
(12) - Ball needle.
(13 and 14) – Valve adaptors.
Publicité
