Publicité
Les langues disponibles
Les langues disponibles
3.
Remove the remaining cutting line.
4.
Clean dirt and debris from all parts.
5.
Align the spool tabs with the tab openings (4) in
the base of the spool (5).
6.
Push the spool cover until it clicks into position.
10.4
INSTALL THE CUTTING LINE
Do not put more than 32.8-ft of .095" line at a time.
1.
Remove the remaining cutting line on the spool.
2.
Line up the slot on the spool cap with the line
exist hole on the trimmer head.
3.
Feed the cutting line through the hole. Push the
cutting line until it exits the opposite hole.
4.
Pull the cutting line through until there is an equal
quantity of cutting line on each side.
English
NOTE
5.
Turn the spool cap clock-wise to wind the cutting
line into the trimmer head.
6.
Keep approximately 5 in of cutting line above out
of each side of the trimmer head.
10.5
REMOVE THE TRIMMER HEAD
1.
Put the metal rod (1) in the motor housing hole
(2) to fix the trimmer head.
2.
Turn the trimmer head clockwise to loosen it. Do
not remove the impeller (3) from the shaft.
1
11
3
2
EN
Publicité
