Gram GASTRO C2 Mode D'emploi page 42

Too high energy consumption:
Ambient temperature too high.
The door is opened too often and/or open for too long.
The door is left open.
Damaged door gasket.
Room temperature setting too low.
Counter too packed with foods - air inlet/outlet blocked.
Condenser mesh filter is clogged.
Warm or hot foods are brought into the cabinet too often.
Counter placed in direct sunlight or close to heat-emitting surfaces.
The default settings have been changed.
User menu
This chapter includes setting of alarm values.
The alarm system is divided into 2 systems. The one system only triggers local alarms, which
means that the error codes are only shown at the display.
The other alarm system triggers both alarms at the display, but it also activates the remote
alarm outlet. Each alarm system operates independently of each other.
If a change of the setting is required, get access to the menu by pushing
3 seconds. The values are changed by pushing the
P
pushing . To exit the menu, push
Menu access P + 1
Local alarm setting
External alarm setting
Temperature offset
(sensor calibration)
Escorting alarm limits
No. of defrosts
765042559
.
LAL LhL °C
Lhd min.
BU On/off
EAL EHL °C
ELL °C
EHd min.
ELd min.
CAL CA K
ALL FAS/ESC
dEF 4
Rev. 003
-
+
or keys. The new setting is saved by
Setting the upper alarm limit. At alarm,
the display shows: A2
Time delay for the upper alarm limit.
Activation of buzzer. The buzzer
sounds at alarms A1, A2. (1=on / 0=off)
Setting the upper alarm limit. At alarm,
the display shows: A3
Setting the lower alarm limit. At alarm,
the display shows: A4
Time delay for the upper alarm limit.
Time delay for lower alarm.
-5...+5 K
Activation of escorting alarm limits.
FAS= fixed limits / ESC = limits
following the setpoint
Number of defrosts in 24 hours.
P + 1
for more than
42