Gram GASTRO C2 Mode D'emploi page 36

Electrical connection
Read the text below thoroughly before electrical connection.
The cabinet is intended for connection to alternating current. The connection
voltage (V) and frequency (Hz) are shown on the name plate in the cabinet (see Fig.
9). Only the supplied cord is to be used.
Never use an extension cord for this appliance!
If a wall socket is placed in a longer distance than the length of the supplied power
cord, contact an electrician to establish a wall socket within the range of the
supplied power cord.
If the product is defective, it must be examined by an authorized technician with
proper knowledge of the product during the guarantee period, if it is a product with
built-in compressor.
If it is a product connected to an external compressor unit, it must be examined by
the company who has connected the product to the unit.
Outside the guarantee period, it is advisable to use the service advised by your
dealer. If this is not the case, assistance is required from an authorized technician
with proper knowledge of the product.
Always disconnect the power if interruptions in power supply occur, and when electrical parts
are removed/put on, and before cleaning and maintenance of the appliance.
Repairing of electrical/technical parts may only be performed by authorized technicians with
proper knowledge of the product.
Do not use the appliance before all coverings are installed, so that live or rotating machine parts
can not be touched.
The counter is not to be used outdoor.
All earthing requirements stipulated by the local electricity authorities must be observed. The
cabinet plug and wall socket should then give correct earthing. If necessary, contact an
electrician.
Make sure the appliance is switched off at the socket before service is performed
on electrical parts. It is not sufficient to switch off the cabinet by the START/STOP
key as there will still be voltage to some electrical parts of the counter.
765042559 Rev. 003 36