Publicité
Les langues disponibles
Les langues disponibles
Controls and features (continued)
Main body - Input terminal
① HDMI 1
④ RS-232C
⑥ 3D SYNCHRO
① HDMI 1 Terminal
② HDMI 2 Terminal
You can connect a device equipped with HDMI
output, etc. It is fitted to the M3 lock hole.
Screw hole depth 3mm. (Reference page: 26)
③ LAN terminal "RJ-45"
This is a LAN-terminal. If one connects an
external PC, it is possible to control this unit by
sending control commands.
(Reference page: 30)
④ RS-232C terminal (male D-Sub 9
pin)
This is a RS-232C interface standard terminal.
If one connects an external PC, it is possible to
control this unit. (Reference page: 29)
⑤ COMPONENT terminal "RCAx3"
It is also used as input terminal for analog
RGB (G on Sync) signals, component (Y, Cb,
Cr) signals, DTV format (Y, Pb, Pr) signals. It
can also be connected with devices, which are
equipped with signal output, etc. (Reference
page: 27)
② HDMI 2
③ LAN
⑥ 3D SYNCHRO terminal
3D synchro emitter: it is connected to the PK-
EM1 (sold separately) when enjoying 3D video
contents. (Reference page: 28)
⑦ TRIGGER terminal(
DC power supply output terminal with DC12V,
100mA. It is used for output signals which control
the vacillating screen responding to the SCREEN
TRIGGER. Please note it can cause damage
to your equipment if the connection is done
incorrectly. (Tip = DC +12 V, Sleeve = GND)
(Reference Page: 29, 59)
⑧ REMOTE terminal to "Stereo mini
jack"
In case it is impossible to use the remote control
due to the installation of this unit's dedicated
BOX or rear projection, one can set up an
external light receiving section. It is used to
connect this external receiver and this unit. There
is no such product as an external light receptor.
Therefore, please consult your authorized JVC
KENWOOD Corporation. (Reference page: 30)
ENGLISH
⑤ COMPONENT
⑧ REMOTE
⑦ TRIGGER
)
17
Publicité
