Pattfield Ergo Tools PE-AA 20 Li Traduction De La Notice Originale page 79

MOUNTING BRANCH JAW CLAMP
1 Place the branch jaw clamp
soleplate 3 from above while pressing
the lock release 9 against the back
pressure lever 10.
INSERTING (REPLACING) SAW
1 BLADE
Rotate the blade clamp 8
clockwise.
Caution! Make sure the battery is
removed from the tool.
ATTACH BATTERY
1 Slide the battery 6 onto the tool until it
clicks into place.
Caution! Only use the batteries
specified in technical data.
BRANCH CUTTING
1 The saw blade must always exceed the
workpiece.
Place the branch jaw clamp of the saw
on the branch you want to cut. Turn on
the tool and push the saw blade
tly against the branch.
156 EN
2 on the 2 Make sure the pins of the branch jaw
clamp 2 fit into the related recesses of
the soleplate 3 and the lock release
snaps into place.
2 Insert the saw blade through the open-
counter ing and release the blade clamp 8.
Caution! The saw blade is sharp.
Wear protective gloves.
2 To release the battery, press the bat-
tery release switch 5 and slide off the
battery 6.
GENERAL CUTTING
2 Place soleplate 3 on the workpiece.
Turn on the tool and push the saw blade
slowly through the workpiece.
1 gen-
1
9
1
2. 2.
1. 1.
1
1
2
2
2
1. 1.
2. 2.
2
EN 157